Voltcraft FSP-1122, 25W 1 Output Variable DC Power Supply, Linear, Bench FSP-1122 Manuale Utente

Codici prodotto

FSP-1122

The output voltage is, depending on the type and design, fixed to 12
V or 13.8 V or 24 V direct voltage (=DC).

The rated current has, depending on the design of the device, a
maximum of 30A.

For a period of a maximum of 5 minutes, the power unit can be
exposed to a slightly higher load (always observe the "Intended Pur-
pose of Use"!).

• Make sure the consumer is switched off.
• Connect the plus pole (+) of the consumer to the red terminal

screw jack "+" (1) and

• the minus pole (-) of the consumer to the black terminal jack "-" (1).
• 4-mm standard connectors could be used for this purpose but we

strongly recommend the connection through 20 A using terminal
screw connectors (the jack heads can be screwed on!).

• The power consumption of the connected consumers is shown

on the current display (2).

Make sure that the consumers are switched off

when connected to the power unit. Sparks may be
generated when a consumer which has been
switched on is connected to the jacks. This may
damage the terminal screw connectors as well as
the connected cables.

If the power units are no longer required, disconnect
them from the mains.

In the case of a short, the mains devices must be
disconnected from any load within a maximum of 5
minutes as they can be destroyed otherwise.

In case of longer operation with the rated load (out-
put voltage times output current), the surface of the
housing or the cooling element becomes very hot.