Lecroy WAVEACE 2022 2-channel oscilloscope, Digital Storage oscilloscope, WaveAce 2022 Manuale Utente
Codici prodotto
WaveAce 2022
WaveAce Remote Control
14
920836 Rev A
Short Form
Long Form
What the Command/Query Does
OFST
OFFSET
Allows output channel vertical offset adjustment.
PACU
PARAMETER_CUSTOM
Controls parameters with customizable qualifiers.
PAVA?
PARAMETER_VALUE?
Returns current parameter, mask test values.
PDET
PEAK_DETECTED
Enables or disables built-in peak detection function.
PERS
PERSIST
Enables or disables the persistence display mode.
PESU
PERSIST_SETUP
Selects display persistence duration.
RCPN
RECALL_PANEL
Recalls a front panel setup from mass storage.
SCSV
SCREEN_SAVE
Enables or disables the screen saver.
STO
STORE
Stores a trace in internal memory or mass storage.
STOP
STOP
Immediately stops signal acquisition.
TDIV
TIME_DIV
Modifies the timebase setting.
TRA
TRACE
Enables or disables the display of a trace.
TRCP
TRIG_COUPLING
Sets the coupling mode of the specified trigger source.
TRDL
TRIG_DELAY
Sets the time at which the trigger is to occur.
TRLV
TRIG_LEVEL
Adjusts the trigger level of the specified trigger source.
TRMD
TRIG_MODE
Specifies the trigger mode.
TRSE
TRIG_SELECT
Selects the condition that will trigger acquisition.
TRSL
TRIG_SLOPE
Sets the trigger slope of the specified trigger source.
VDIV
VOLT_DIV
Sets the vertical sensitivity.
WAIT
WAIT
Prevents new analysis until current is completed.
WF
WAVEFORM
Transfers a waveform from controller to scope.
WFSU
WAVEFORM_SETUP
Specifies amount of waveform data to go to controller.