Lecroy WAVEACE 1002 2-channel oscilloscope, Digital Storage oscilloscope, WaveAce 1002 Manuale Utente
Codici prodotto
WaveAce 1002
WaveAce 1000/2000
WA1K2K-OM-E RevB
27
Vertical Settings and Channel Controls
Vertical Settings and Channel Controls
When you turn a channel trace ON, the Channel menu opens. The
Channel menu page shown (1/3, 2/3, or 3/3) is always based on the most
recent trace activated.
Channel menu page shown (1/3, 2/3, or 3/3) is always based on the most
recent trace activated.
Choosing Coupling
You can choose one of these input coupling modes:
DC - Passes both AC and DC components of the input signal.
AC - Blocks the DC component of the input signal and attenuates
signals below 10 Hz.
signals below 10 Hz.
GND - Disconnects the input signal. Use GND coupling to display a
zero-volt waveform. Internally, the channel input is connected to a
zero-volt reference level.
zero-volt waveform. Internally, the channel input is connected to a
zero-volt reference level.
PLEASE NOTE THE FOLLOWING:
If the channel is set to DC coupling, you can quickly measure the
DC component of the signal by simply noting its distance from the
ground symbol.
DC component of the signal by simply noting its distance from the
ground symbol.
If the channel is set to AC coupling, the DC component of the
signal is blocked allowing you to use greater sensitivity to display
the AC component of the symbol.
signal is blocked allowing you to use greater sensitivity to display
the AC component of the symbol.