Fluke i1010KITClip-on ammeter adapter 1 - 600 A (up to 10kHz) (±2% +0.5 A) 30 mm 2096998 Manuale Utente

®

i410/i1010

P

 

•

  Avoid working alone to ensure that assistance can be rendered.

•

  Do not use the clamp if the clamp or leads appear damaged, or if you

suspect that the clamp is not operating properly.

•

  Use extreme caution when working around bare conductors or bus

bars. Accidental contact with the conductor could result in electric
shock.

•

  Use caution when working with voltages above 30V rms or 60V dc.

Such voltages pose a shock hazard.

•

  Never use the clamp on a circuit with a voltage higher than 600V

(CAT. III) or a frequency higher than 400 Hz (i410) or 2 kHz (i1010.)
The clamp may be damaged if these limits are exceeded.

•

  Use the clamp only as specified in this instruction sheet; otherwise,

the protection provided by the clamp may be impaired.

•

  Read the operating instructions before use and follow all safety

information.

•

  CAT. III - Industrial Locations (IEC 1010-1).

PN 617677  September 1996, Rev.1, 4/97



1996, 1997 Fluke Corporation. All rights reserved. Printed in Thailand.