MPIO MG100 2GB 1001197 Manuale Utente

6

7

  To disconnect MG100 from a Mac
•  Press COMMAND-E or select [Eject “MG100”] in the File menu in Finder. If you have a 
  mouse with two mouse buttons, right click on MG100 icon on the desktop and  
  choose [Eject “MG100”]. 
•  Wait until the MG100 icon disappears from the desktop.
•  Remove MG100 from your Mac.

 Disconnecting MG100 without properly going through “Eject” process may result in  

  loss of data.

  To turn on MG100
•  Press and hold (       ).
  To turn off MG100
•  Press and hold (       ).
 
 

 MG100 will automatically power off three minutes after it was put on pause by 

  default.

  To change the volume
•  Press (+) to raise or (-) to lower the volume. Hold either button to rapidly raise or 
  lower the volume.

  To switch between MTP and MSC modes
•  While MG100 is plugged into your computer, press the Menu (       ) button to 
  switch between the MTP and the MSC modes.  

 If you are using Windows98 SE and need to install the USB driver manually, please  

  refer to Microsoft Knowledge Base or to MPIO Web Support.

  To disconnect MG100 from a PC
•  Place mouse cursor on “Stop a Hardware Device” icon in the system tray, and click  
  right mouse button.
•  Select “Stop USB Mass Storage Device.”.
•  Select USB Mass Storage Device from the list of hardware, and click the [Stop] 
  button. 
•  When the “Stop a Hardware Device” window appears, select MPIO MG100 USB  
  Device. 
•  Finally, click [OK] and disconnect the USB cable.
  Windows XP: 
  Disconnect the USB cable when the “Safe to remove hardware” message appears. 
  Windows 2000: 
  Disconnect the USB cable by clicking the [OK] button after the “Safely Remove Hardware”  
  message appears.

 Disconnecting MG100 without going through the above steps may result in loss of  

  data.