Renkforce Funk-Wetterstation mit Wetterforecast Wireless Weather Station AOL-5052B Scheda Tecnica

 First take the outdoor sensor into operation and then the weather station. For

correct calculation of the barometric pressure, the weather station needs to

know the approximate altitude of your place of residence. You can find it, e.g.,

on the website of your town or municipality.

•  Open the battery compartment of the outdoor sensor by pulling the battery compartment

lid off downwards.

•  Insert two type AAA/Micro batteries in the battery compartment in the correct polarity

(observe plus/+ and minus/-). The display of the outdoor sensor briefly shows all display

segments, and then the first measured value for tempertature and humidity.

•  Select the transmission channel of the outdoor sensor by briefly pushing the button

„CH“  in  the  battery  compartment  of  the  outdoor  sensor.  The  display  of  the  outdoor

sensor shows the current transmission channel („CH1“ = channel 1, „CH2“ = channel 2,

„CH3“ = channel 3).

 When operating only a single outdoor sensor, always set the channel to 1. If several

outdoor sensors are operated (up to 3 are possible), set a different channel for each

outdoor sensor.

•  Briefly push the button „°C/°F“ in the battery compartment of the outdoor sensor to

switch between the temperature unit °C (degrees Celsius) and °F (degrees Fahren-

heit).

•  Close the battery compartment of the outdoor sensor again.

 The LED above the LC display flashes briefly (approx. every 50 seconds) when

the outdoor sensor sends the measured values. The display of the outdoor

sensor briefly shows a radio tower symbol.

•  Open the battery compartment on the back of the basis station.
•  Insert two type AA/Mignon batteries in the battery compartment in the correct polarity

(observe plus/+ and minus/-).

•  Close the battery compartment again.
•  Right after inserting the batteries into the weather station, all display segments appear

briefly and a beep is emitted.