Renkforce Digitale Funk-Wetterstation Wireless Weather Station AOK-5055 Scheda Tecnica
Codici prodotto
AOK-5055
3
NOTES:
First insert the batteries of main unit, then insert the batteries of the outdoor sensor in 3
minutes after the main unit is powered on, to assure of the sensor data received well.
In case of the outdoor sensor data received failure, pls press ALARM key for more than 3
seconds to synchronize the RF signal.
minutes after the main unit is powered on, to assure of the sensor data received well.
In case of the outdoor sensor data received failure, pls press ALARM key for more than 3
seconds to synchronize the RF signal.
Every time the batteries are replaced , the main unit will loose all the weather data.
Every time the batteries are replaced , the thermo-hygro sensor will sychronize with the main
Unit again.you must press the
ALARM key for more than 3 seconds to synchronize the RF
signal.
In case of any failure of RF, pls reset the sensor to and press
ALARM receive again.
Mounting the main unit
The main unit can be placed onto any flat surface or wall mounted at the desired location by
Hanging hole, It is important to check that the radio signal can be received before mounting.
Hanging hole, It is important to check that the radio signal can be received before mounting.
Mounting the outdoor sensor onto the stainless steel mast
For accurate results, the outdoor sensor mast should be securely mounted onto a horizontal
surface and in an open area away from trees and other coverings where rainfall or wind
speed may be reduced causing inaccurate reading.
surface and in an open area away from trees and other coverings where rainfall or wind
speed may be reduced causing inaccurate reading.