ASUS Barebone V3-P5G33 AS V3-P5G33 ID1 Manuale Utente

Codici prodotto
AS V3-P5G33 ID1
Pagina di 106
vi
Notices
Federal Communications Commission Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to 
the following two conditions:
•  This device may not cause harmful interference, and
•  This device must accept any interference received including 
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a 
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits 
are designed to provide reasonable protection against harmful interference 
in a residential installation. This equipment generates, uses and can radiate 
radio frequency energy and, if not installed and used in accordance with 
manufacturer’s instructions, may cause harmful interference to radio 
communications. However, there is no guarantee that interference will 
not occur in a particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can be determined by 
turning the equipment off and on, the user is encouraged to try to correct 
the interference by one or more of the following measures:
•  Reorient or relocate the receiving antenna.
•  Increase the separation between the equipment and receiver.
•  Connect the equipment to an outlet on a circuit different from that to 
which the receiver is connected.
•  Consult the dealer or an experienced radio/TV technician for help.
Canadian Department of Communications Statement
This digital apparatus does not exceed the Class B limits for radio noise 
emissions from digital apparatus set out in the Radio Interference 
Regulations of the Canadian Department of Communications.
This class B digital apparatus complies with Canadian ICES-003.
WARNING!  The use of shielded cables for connection of the monitor to 
the graphics card is required to assure compliance with FCC regulations. 
Changes or modifications to this unit not expressly approved by the 
party responsible for compliance could void the user’s authority to 
operate this equipment.