Gigaset C475IP ECO DECT S30852-H1917-M101 Manuale Utente
Codici prodotto
S30852-H1917-M101
31
SMS (text messages)
Gigaset C470/C475 / Grossbritannien / A31008-M1902-L101-1-7619 / sms_BRD_neutral.fm / 6.8.07
Ve
rs
ion 4,
16
.09.
2005
Sending an SMS through another SMS
centre
¤
Activate the SMS centre (2 to 4) as the
active send service centre.
¤
Send the SMS.
SMS on a PABX
u You can only receive an SMS when the
Calling Line Identification is for-
warded to the extension of the PABX
(CLIP). The CLIP evaluation of the
phone number for the SMS centre takes
place in your Gigaset.
u If required, you must prefix the number
for the SMS centre with the access code
(depending on your PABX).
If in doubt, test your PABX, e.g. by
If in doubt, test your PABX, e.g. by
sending an SMS to your own number:
once with and once without the access
code.
u When you send SMS messages, your
sender number may be sent without
your extension number. In this case the
recipient cannot reply to you directly.
Sending and receiving SMS messages on
ISDN PABXs is only possible via the MSN
number assigned to your base station.
Activating/deactivating SMS
function
function
If you deactivate the SMS function, you
cannot send or receive any SMS messages
with your phone.
The settings which you have made for
The settings which you have made for
sending and receiving SMS messages (e.g.
the call numbers of the SMS centres) and
the entries in the incoming and draft mes-
sage lists are saved even after you turn off
your phone.
v Open
v Open
menu.
5 5 O 2 L
Enter the digits.
Q
§OK§
Deactivate SMS function.
Or:
§OK§
Activate SMS function (default
setting).
SMS troubleshooting
Error codes when sending
Self-help with errors
The following table lists error situations
and possible causes and provides notes on
troubleshooting.
E0 Calling Line Identification permanently
withheld (CLIR) or Calling Line
Identification not activated.
FE Error occurred during SMS transfer.
FD Connection to SMS centre failed, see self-
FD Connection to SMS centre failed, see self-
help.
You cannot send messages.
1. You have not requested the CLIP service
1. You have not requested the CLIP service
(Calling Line Identification Presentation).
¥
Ask your service provider to enable this
service.
2. SMS transmission has been interrupted
(e.g. by a call).
¥
Re-send the SMS.
3. Network provider does not support this fea-
ture.
4. No number or an invalid number is entered
for the SMS centre set as the active send
service centre.
¥
Enter the number (page 30).
You receive an incomplete SMS.
1. Your phone's memory is full.
1. Your phone's memory is full.
¥
Delete old SMS messages (page 28).
2. The service provider has not yet sent the
rest of the SMS.