Insys GPRS 5.0 serial 11-02-01-03-10.014 Manuale Utente
Codici prodotto
11-02-01-03-10.014
INSYS GPRS 5.0 serial
Functions
Mai 06
41
Alternatively, the access control can be set, changed
or deleted using the terminal program:
Activating selective call acceptance
or deleted using the terminal program:
Activating selective call acceptance
AT**CLIP=1
Deactivating selective call acceptance
AT**CLIP=0
Note: The settings are only changed after the device
has been reset.
Incoming calls of numbers which are not allowed are
immediately rejected to keep the line free. They can
also not be accepted manually. The caller receives the
busy signal.
immediately rejected to keep the line free. They can
also not be accepted manually. The caller receives the
busy signal.
ATA
BUSY
For each incoming call, the phone number is
displayed as well.
displayed as well.
RING
+CLIP:
„+49941586920“,145,,,,0
The released number has to be configured in exactly
the same format as for a call.
AT**CLIP1=
+49941586920
Note: The transmitted format of the number depends
on the provider – e.g. the leading “+49” may
be replaced by “0049”. We urgently recom-
mend verifying the number by placing a test
call.
be replaced by “0049”. We urgently recom-
mend verifying the number by placing a test
call.
It is possible to allow whole blocks of numbers: The
wildcard character * replaces exactly any single digit
wildcard character * replaces exactly any single digit
AT**CLIP1=
+499415869**
6.2
Establishing a Connection by Callback
Using callback functions, the INSYS GPRS 5.0 can be forced to automatically establish a
data connection as soon as a callback is indicated.
Permitted phone numbers are stored and linked to a destination address (IP address,
domain name or phone number) in the configuration.
The connection setup can be set with a call using the HSComm. Click on the tab "Access
Control/Autodial”.
data connection as soon as a callback is indicated.
Permitted phone numbers are stored and linked to a destination address (IP address,
domain name or phone number) in the configuration.
The connection setup can be set with a call using the HSComm. Click on the tab "Access
Control/Autodial”.
The callback function can be activated via the HSComm by entering the phone number
and selecting “Callback”.
and selecting “Callback”.