Insys ISDN Terminal Adapter 4.0 11-02-01-02-00.015 Manuale Utente
Codici prodotto
11-02-01-02-00.015
Command Overview
39
Version 2.02 – 01.04
Command Description
The value will be changed by setting the B channel protocol (ATBx).
AT**K
Set Layer 2 window size
Sets window size x layer 2 protocol B channel:
Sets window size x layer 2 protocol B channel:
x
= 1 ..7, default: 7
AT**K
=x
The default value is dependent of the selected B channel protocol.
AT**PTP
Set ISDN interface type
AT**PTP
AT**PTP
=0
select point to multipoint mode (to connect ISDN terminals,
default)
default)
AT**PTP
=1
select point to point mode (to connect ISDN switching systems)
AT**RPWD
Password for remote configuration
Sets password for remote configuration to nn (1..32 chars) Default: no password.
Sets password for remote configuration to nn (1..32 chars) Default: no password.
AT**RPWD
=nn
AT**SPID
Set SPID (optional)
For ISDN lines in the U.S. you have to set the SPID. You get it from your ISDN pro-
vider.
For ISDN lines in the U.S. you have to set the SPID. You get it from your ISDN pro-
vider.
AT**SPID1
=xxxx Set
SPID
1
AT**SPID2
=xxxx Set
SPID
2
AT**<cmd>
Execute configuration command
Executes a configuration command.
Executes a configuration command.
7.3 S Register
The INSYS ISDN TA has status register which control the operation.
S register can be read and written using the ATS command. Certain S registers can
only be read, while others can only be set within a limited range of values.
S register can be read and written using the ATS command. Certain S registers can
only be read, while others can only be set within a limited range of values.
Register Description
S0
0:
no automatic call acceptance, acceptance of an incoming call is con-
trolled by the data terminal (command ATA after RING)
trolled by the data terminal (command ATA after RING)
1:
immediate call acceptance by the INSYS ISDN TA (default)
2..n
:
call acceptance by the INSYS ISDN TA after n "RING" messages
Note:
The time between 2 ring messages can be set with the command “ring-
timer” (default = 5 s.)
timer” (default = 5 s.)
S1
Ring tone counter (read only)
S2
Escape character (default = 43h)
S3
Return character (default = 0Dh)
S4
Line feed character (default = 0Ah)
S5
Backspace character (default = 1Ah)
S7
Waiting time for carrier signal in seconds (default = 30)
S9
Set PNP functionality for Windows95 (default=1, enabled)