Futaba 6J F4103 Scheda Tecnica

the DATA INPUT lever upward.  The OFF indication will begin to blink rapidly and will soon change to 
display ON.

5) Press and hold the END button to exit the programming menu.

The servo reversing function is used to change the direction that a servo responds to a control input from 
the transmitter (stick or switch).  After using the reversing function, check all the controls on the model to 
be certain they are operating in the correct direction and that you did not inadvertently reverse a servo other 
than the one intended.  Reversing the wrong servo (and not checking the response of the controls before each 
=~ +   “

Note: Reversing the throw of a servo channel will affect all mixings, etc. that interact with this channel.  For 
&!##   #  #'### + =! 
(if active).  As such, we strongly suggest adjusting the servo reversing as one of the earliest steps in the 
programming of the T6J.

1) Turn the transmitter on.

2) Press and hold the MODE button to access the programming mode.

3) Press either the MODE key OR the END key to scroll through the function menus. 

Continue pressing the MODE or END key until the reverse (REVR) menu appears 
on screen. 

4) Press the SELECT key to select the channel you wish to reverse.

5) Push the DATA INPUT lever downward for 0.5 seconds to reverse (REV) the servo.  Press the DATA 

INPUT lever upward for 0.5 seconds to make the servo operate in a normal (NOR) direction. 

6) Repeat the steps above to bring forth and modify any other channels for which the travel direction is to be 

altered.

7) Press and hold the END button to exit the servo reverse menu.