Reely QuadroCopter combi-board 450 + 650 208944 208944 Scheda Tecnica

The desired RC input for switching the light effect can be set using the jumper SW1. Always
connect the upper and lower contacts with the jumper. Assignment is as follows:
Servo selection 1 = channel 8
Servo selection 2 = channel 7
Servo selection 3 = channel 6
Servo selection 4 = channel 5
In the illustration on the side, the jumper is set to servo selection 1. You can now switch the set
light mode at the transmitter via channel 5.

Control via channels 5, 6, 7 or 8 is only possible where they are also generated by
the main control. Signal generation is independent from the composite signal con-
verter!
If this is not the case, you are able to directly feed an external servo signal (PPM) into
the left connection contact of the “X9” plug of an unassigned receiver output (e.g.
channel 9).
If you do not use any RC input and thus waive the possibility of switching, PPM
switching state “high” will always be active!

1

2

3

4