Jeti 4-channel receiver 2.4 GHz FHSS with Connector system JR 80001222 Manuale Utente
Codici prodotto
80001222
computer radio control system
EN
labelled CH xx.
- PPM off: for the given output there is no PPM signal generated or
received
- PPM input: for the given input there a PPM signal is expected from
the connected receiver
- PPM output: the receiver channel will generate a PPM signal
- PPM off: for the given output there is no PPM signal generated or
received
- PPM input: for the given input there a PPM signal is expected from
the connected receiver
- PPM output: the receiver channel will generate a PPM signal
PPM error code- in the case that one of the SAT1/2 outputs is set to
PPM input mode, an acoustic signal can be setup to announce
when this connected signal is missing. By loading a character from
the Morse alphabet you may set-up tones, which will acoustically
announce the absence of a PPM signal at the given receiver output.
This acoustical signal is generated by the transmitter module. In the
factory default setup the acoustical signal is switched off.
PPM input mode, an acoustic signal can be setup to announce
when this connected signal is missing. By loading a character from
the Morse alphabet you may set-up tones, which will acoustically
announce the absence of a PPM signal at the given receiver output.
This acoustical signal is generated by the transmitter module. In the
factory default setup the acoustical signal is switched off.
SetInChannel - assignment of an actual output (labelled as Yx)or
input channel (labelled as Chx)
input channel (labelled as Chx)
Output Trim - neutral throw setup for receiver output.
Gain A - amplification of the output throw in the negative half-plain
A (from -150 to 0%)
A (from -150 to 0%)
Gain B - amplification of the output throw in the positive half-plain
B (from 0% to 150%)
B (from 0% to 150%)
Signal Fault - setup of the receiver behaviour in case of signal loss,
„hold“- holds the most recent control throw, „out off“ – output
switch-off(no signal generated), „failSafe“ – moves to preset throws
for the individual outputs.
„hold“- holds the most recent control throw, „out off“ – output
switch-off(no signal generated), „failSafe“ – moves to preset throws
for the individual outputs.