Blade 180 QX HD RTF BLH7400 Scheda Tecnica

Replace the transmitter batteries when the power LED fl ashes and the 
transmitter beeps.

1. Lower the throttle to the lowest setting.
2. Power on the transmitter.
3.  Install the battery by sliding it into the battery mounting slot below the 5-in-1 control unit. Slide the battery into the 

slots with the label facing upward so that the battery key molded into the battery end-cap comes in contact with
the key on the battery slot.

4.  Connect the battery cable to the 5-in-1 control unit.
5. Place the quadcopter on its skids on a fl at surface and leave the aircraft still until the LED on the 5-in-1 control unit

indicates one of the following fl ight modes:

Solid blue: Stability, Low-angle mode
Slow blue fl ashing: Stability, High-angle mode
Solid red: Agility mode

If the LED is rapidly fl ashing blue, see the Transmitter and Receiver Binding section.

CAUTION: Always disconnect the Li-Po battery from the aircraft when not fl ying to avoid over-discharging the
battery. Batteries discharged to a voltage lower than the lowest approved voltage may become damaged,

resulting in loss of performance and potential fi re when batteries are charged.

Install the landing gear using the
four included screws.