Peli PEL1965Z0 Neon yellow PEL1965Z0 Scheda Tecnica
Codici prodotto
PEL1965Z0
TRAC10ATEX11241X, 2010-07-20
Page 2 of 4
13
SCHEDULE TO EC TYPE EXAMINATION CERTIFICATE
14
TRAC10ATEX11241X
15
General description of equipment or protective system included within the scope of this certificate
The flashlight, model 1965 is a portable alkaline battery powered torch. The unit comprises a main PCB with
various components and a PCB with an LED, along with a reflector, and a battery compartment all contained
within an enclosure constructed of plastic with a clear plastic lens. The torch is powered by two “AAA”
alkaline batteries connected in series. As a part of this evaluation, the following cells were assessed and
approved for use:
various components and a PCB with an LED, along with a reflector, and a battery compartment all contained
within an enclosure constructed of plastic with a clear plastic lens. The torch is powered by two “AAA”
alkaline batteries connected in series. As a part of this evaluation, the following cells were assessed and
approved for use:
o
Philips, PN LR03 (Powerlife)
o
Panasonic, PN LR03 (Xtreme Power)
o
Duracell, PN MN2400
o
Energizer, PN E92
A list of controlled Manufacturer’s Documents is given in Appendix A to this schedule.
16
Test report No.:
16-0163-006113.
17
Special conditions for safe use
1. Use only Duracell MN2400 LR03, Energizer E92 LR03, Philips PN LR03 (Powerlife) or Panasonic PN
LR03 (extreme power) AAA alkaline batteries.
2. To reduce risk of explosion do not mix old with new batteries, or mix batteries from different
manufacturers.
3. Do not change batteries in hazardous locations.
18
Essential health and safety requirements
Covered by application of the standards listed in section 9 of this certificate and the assessment conducted
in the test report listed in section 16 of this certificate.
in the test report listed in section 16 of this certificate.
19
Additional information (including special conditions for manufacture)
1. Polycarbonate for Battery Compartment Insulator must be at least 0.5mm thick and cover the entire
length of the cells.
2. The high temperature epoxy used to encapsulate fuse (F1) and the inside of the lamp module must
completely fill module except for the top surface of the LED board.
Photographs