Insys Modem 56k 4.1 11-02-01-01-40.028 Manuale Utente

Codici prodotto

11-02-01-01-40.028

AT Command Set

INSYS Modem 336/56k 4.1 (UL)

Command

Description

ATZ<n>

Software reset

The command causes the modem to perform a software reset. The modem will load the
default saved by the user (according to the parameter). If no parameter is specified, the
user default 0 is loaded.

ATZ0

Software reset; afterwards the user default 0 is loaded.

ATZ1

Software reset; afterwards the user default 1 is loaded.

AT&Z<n>

Save phone numbers

The command saves four entries permanently in the EEPROM. Each entry may consist of
up to 35 characters. The entries may be overwritten and must comply with the dialing
string as described in the ATD command.

AT&Z<n>=xxx

This is the number of the list entry (from 0 to 3).

xxx

This is the dialing string with the phone number.

Layout of the alarm functions and security callback:

AT&Z0=xxx

Number of the modem or fax for a simple alarm message

Service center number of the GSM provider for SMS access

AT&Z1=xxx

Enter the callback number for security callback

AT&Z2=xxx

Number of the mobile phone for simple alarm messages

AT&Z3=xxx

Number of the fax machine for collective alarm messages

Change from data mode to command mode (online command mode).

1 second pause before and after the entry, no <CR>. After the response OK, an additional
waiting period of 1 second for the re-entering of AT commands must be observed.

Start of the remote configuration at the local modem

After the 4 escape characters **** were entered at the local modem (1 second pause
before and after the entry, no return - <CR> -), the remote configuration at the remote
terminal is activated. After the response OK, an additional waiting period of 2 seconds for
the re-entering of AT commands must be observed.

July 06