ConiuGo 700100107 EasyGuard II 700100107 Manuale Utente

Codici prodotto

700100107

Revision 9.0

GSM Alarm & Telemetry systems

Which connection shall be modified <0=back> ?

Example:

When unused or disconnected any digital input is in condition "1" and can be

switched to "0" for simple tests by connecting it to the extended ground ("

⊥

") of the

Module. In that case the "0" – as shown here on input no. 1 – has to be set in the

combination table in order to trigger (switch on) outpin_1.

No. D_In PP A_In TIME GSM SMS HTime R OUTPTNAME
1. 0XXXXXXXXXXX X XXXX XXX X XXXX ---- - SMS_1

Running the program you now can watch how the output reacts on an impulse at the

digital input.

Depending on the GSM provider you have choosen the trans-

mission of SMS less or more can be delayed. To avoid an unac-

ceptable delay of the SMS make sure to contract with a GSM

provider which guarantees to you the transmission time that is

necessary.

Please note that it could be dangerous to trigger connected

units (e.g. heaters or coolers) because of the possible lost of the

connection to the GSM networks.

<2> Digital Outputs:

These are the digital outputs (relay contacts). To switch them you must have to com-

bine in the connection settings with the events on which they have to react (time,

digital input, incoming SMS, etc.).

Connection Settings – Digital Outputs
--------------
No. D_In         PP   A_In Time  GSM     SMS     HTime   R   NAME
1. XXXXXXXXXXXX  X   XXXX XXX    X    XXXXXXXX      0   N   OUTPIN_1
2. XXXXXXXXXXXX  X   XXXX XXX    X    XXXXXXXX      0   N   OUTPIN_1
3. XXXXXXXXXXXX  X   XXXX XXX    X    XXXXXXXX      0   N   OUTPIN_1
4. XXXXXXXXXXXX  X   XXXX XXX    X    XXXXXXXX      0   N   OUTPIN_1
5. XXXXXXXXXXXX  X   XXXX XXX    X    XXXXXXXX      0   N   OUTPIN_2
6. XXXXXXXXXXXX  X   XXXX XXX    X    XXXXXXXX      0   N   OUTPIN_2
7. XXXXXXXXXXXX  X   XXXX XXX    X    XXXXXXXX      0   N   OUTPIN_2
8. XXXXXXXXXXXX  X   XXXX XXX    X    XXXXXXXX      0   N   OUTPIN_2
9. XXXXXXXXXXXX  X   XXXX XXX    X    XXXXXXXX      0   N   OUTPIN_3