Texas Instruments TPS7A6333EVM Evaluation Module TPS7A6333EVM TPS7A6333EVM Scheda Tecnica
Codici prodotto
TPS7A6333EVM
5
1.23 * (1
)
4
OUT
R
V
R
=
+
User
'
s Guide
SLVU477
–
June 2011
TPS7A63xxEVM Evaluation Module
1
Introduction
The Texas Instruments TPS7A63xxQPWP EVM evaluation module (EVM) helps designers evaluate the
operation and performance of the TPS7A63xxQPWP linear regulator.
operation and performance of the TPS7A63xxQPWP linear regulator.
The EVM contains one linear regulator (see
Table 1. Device and Package Configurations
CONVERTER
IC
PACKAGE
U1
TPS7A63xxQPWPRQ1
(1)
PWP-14
(1)
where xx is 01 for adjustable output voltage, 33 for 3.3V output and 50 for 5.0V output.
2
Setup
This section describes the jumpers and connectors on the EVM as well and how to properly connect, set
up and use the TPS7A63xxQPWP EVM.
up and use the TPS7A63xxQPWP EVM.
2.1
Input/Output Connector Description
VBAT is the protected power input for the regulator. The test point provides a power (Vbat) connection
and a reverse battery protection diode to allow the user to power the EVM.
and a reverse battery protection diode to allow the user to power the EVM.
GND is the ground return for the regulator. The EVM provides four GND test points to allow the user to
power the EVM, connect the load and attach an oscilloscope ground lead.
power the EVM, connect the load and attach an oscilloscope ground lead.
VOUT is power output for the regulator. The test point provides a connection to attach a load to the EVM.
The TPS7A6301QPWP EVM is setup to provide a 5V output voltage, but the feedback resistors can be
changed to set the output voltage to a value between 2.5V and 7V using
changed to set the output voltage to a value between 2.5V and 7V using
Feedback Resistor Calculation
(1)
The TPS7A6333QPWP has a fixed outputvoltage of 3.3V without external resistors. R4 and R5 are not
populated on the TPS7A6333QPWP EVM.
The TPS7A6350QPWP has a fixed outputvoltage of 5.0V without external resistors. R4 and R5 are not
populated on the TPS7A6350QPWP EVM.
populated on the TPS7A6333QPWP EVM.
The TPS7A6350QPWP has a fixed outputvoltage of 5.0V without external resistors. R4 and R5 are not
populated on the TPS7A6350QPWP EVM.
EN is a test point to monitor the Enable input to the device. It can also be used to provide an enable signal
to the device from an outside source, if the EN jumper is left open. The EN jumper will disable the
regulator when removed and enable the regulator when installed.
to the device from an outside source, if the EN jumper is left open. The EN jumper will disable the
regulator when removed and enable the regulator when installed.
Figure 1. Enable Jumper
1
SLVU477
–
June 2011
TPS7A63xxEVM Evaluation Module
Copyright
©
2011, Texas Instruments Incorporated