Texas Instruments DAC8801EVM Evaluation Module DAC8801EVM DAC8801EVM Scheda Tecnica
Codici prodotto
DAC8801EVM
www.ti.com
Using the DAC8811EVM with DXP
The hardware must be configured such that the DAC8811EVM is plugged onto the MMB0 aligning female
connectors J4, J2 and J6 (on the bottom side of the DAC8811EVM) with male connectors J7, J4 and J5
on the MMB0. The assembled hardware is shown in
connectors J4, J2 and J6 (on the bottom side of the DAC8811EVM) with male connectors J7, J4 and J5
on the MMB0. The assembled hardware is shown in
CAUTION
Use caution when assembling the boards. It is possible to misalign the
connectors and damage both the EVM and the motherboard.
connectors and damage both the EVM and the motherboard.
CAUTION
DO NOT connect the MMB0 to your PC before installing the DXP software as
described in the DXP User’s Guide. Installing the software first ensures that the
necessary drivers are properly loaded to run the hardware.
described in the DXP User’s Guide. Installing the software first ensures that the
necessary drivers are properly loaded to run the hardware.
Figure 10. MMB0 with DAC8811EVM Installed
13
SLAU151A – January 2005 – Revised November 2009
DAC8801/11EVM
Copyright © 2005–2009, Texas Instruments Incorporated