Texas Instruments TMDSEMU560V2STM-U - Blackhawk XDS560v2 System Trace USB Emulator TMDSEMU560V2STM-U TMDSEMU560V2STM-U Scheda Tecnica
Codici prodotto
TMDSEMU560V2STM-U
Mechanical Specifications
2-2
2.1
Mechanical Specifications
The Texas Instruments XDS560 emulator consists of a PCI-based emulator
board and a complementary interconnecting target cable assembly.
board and a complementary interconnecting target cable assembly.
The PCI-based emulator board is designed to operate as an universal card in
either a 5.0-V, 3.3-V or universal 32-bit PCI expansion slot.
either a 5.0-V, 3.3-V or universal 32-bit PCI expansion slot.
The PCI interface is complaint with revision 2.2 of the PCI bus specification.
The emulator board uses only the +5 V and requires a maximum current of 2.0
amperes, derived from applicable pins within the PCI slot.
The emulator board uses only the +5 V and requires a maximum current of 2.0
amperes, derived from applicable pins within the PCI slot.
2.1.1
Mechanical Dimensions
Figure 2−1 shows the mechanical dimensions of the PCI-based emulator
board. The emulator board requires a full-height,
board. The emulator board requires a full-height,
¾
-length PCI slot to accom-
modate the installation of the board.
Figure 2−1. XDS560 PCI Emulator Dimensions
PCI Fingers
XDS560 Pod
Connector
7.875 in
4.20 in
The target cable/pod consists of a 1.5m section of jacketed cable, an active
cable pod, and a short section of jacketed cable that connects to the target sys-
tem. The overall cable length is approximately 1.7 meters.
cable pod, and a short section of jacketed cable that connects to the target sys-
tem. The overall cable length is approximately 1.7 meters.
Figure 2−2 and Figure 2−3 illustrate the mechanical dimensions for the target
cable pod assembly.
cable pod assembly.