Texas Instruments INA230 Evaluation Module INA230EVM INA230EVM Scheda Tecnica
Codici prodotto
INA230EVM
INA230EVM Hardware
3.4
Connecting the USB Cable to the SM-USB-DIG Platform
Once power is connected, as shown in
, the computer typically responds with a Found New
Hardware, USB Device pop-up dialog. The pop-up window typically changes to Found New Hardware,
USB Human Interface Device. This pop-up indicates that the device is ready to be used. The SM-USB-
DIG Platform uses the human interface device drivers that are part of the Microsoft
USB Human Interface Device. This pop-up indicates that the device is ready to be used. The SM-USB-
DIG Platform uses the human interface device drivers that are part of the Microsoft
®
Windows
®
operating
system.
Figure 6. Connecting the USB Cable to the SM-USB-DIG Platform
In some cases, the Windows Add Hardware Wizard may pop up. If this prompt appears, allow the system
device manager to install the human interface drivers by clicking Yes when requested to install drivers.
Windows then confirms installation of the drivers with the message shown in
device manager to install the human interface drivers by clicking Yes when requested to install drivers.
Windows then confirms installation of the drivers with the message shown in
.
Figure 7. Confirmation of SM-USB-DIG Platform Driver Installation
8
INA230EVM Evaluation Board and Software Tutorial
SBOU124 – March 2012
Copyright © 2012, Texas Instruments Incorporated