Texas Instruments 12V Input, 1.5V Output, 10A Sync Buck Converter Evaluation Module TPS40190EVM-001 TPS40190EVM-001 Scheda Tecnica

System Power Management – DC/DC Controllers 

The TPS40190EVM-001 evaluation module (EVM) is a synchronous buck converter providing a fixed 1.5V output 
at up to 10A from a 12V input bus.  The EVM is designed to start up from a single supply, so no additional bias 
voltage is required for start-up.  The module uses the TPS40190 Reduced Pin Count Synchronous Buck 
Controller. 

TPS40190EVM-001 is designed to use a regulated 12V (10V-14V) bus to produce a high current, regulated 1.5V 
output at up to 10A of load current.  The TPS40190EVM-001 is design to demonstrate the TPS40190 in a typical 
regulated bus to low-voltage application while providing a number of test points to evaluate the performance of 
the TPS40190 in a given application.  The EVM can be modified to support output voltages from 0.9V to 3.3V by 
changing a single set resistor.  

•  Non-Isolated Medium Current Point of Load and low voltage bus converters. 

• Networking 

Equipment 

• Telecommunications 

Equipment 

•  DC Power Distributed Systems 

•  10V - 14V input range 

•  1.5V fixed output, adjustable with single resistor 

•  10Adc Steady State Output Current 

•  300kHz switching frequency (Fixed by TPS40190) 

•  Single Main Switch N-channel MOSFET and Single Synchronous Rectifier N-channel MOSFET 

•  Double Sided 3” x 3” PCB with all components on top side 

•  Active Converter uses less than 1.2 square inches – 1.775 x 0.670 

•  Convenient test points for probing critical waveforms and non-invasive loop response testing