Texas Instruments AMC80 Evaluation module AMC80EVM AMC80EVM Scheda Tecnica
Codici prodotto
AMC80EVM
www.ti.com
AMC80EVM Hardware Overview
3.2
Connecting the Hardware
To connect the AMC80 Test Board and the SM-USB-DIG Platform together, gently slide the male and
female ends of the 10-pin connectors together, as illustrated in
female ends of the 10-pin connectors together, as illustrated in
. Make sure that the two
connectors are completely pushed together; loose connections may cause intermittent EVM operation.
Figure 5. Connecting the SM-USB-DIG Platform to the AMC80 Test Board
3.3
Loading the Software
shows the typical response to connecting the SM-USB-DIG Platform board to a PC USB port for
the first time. Typically, the computer responds with a Found New Hardware, USB Device pop-up dialog.
The pop-up window typically changes to Found New Hardware, USB Human Interface Device. This
pop-up indicates that the device is ready to be used. The SM-USB-DIG Platform uses the human interface
device drivers that are part of the Microsoft
The pop-up window typically changes to Found New Hardware, USB Human Interface Device. This
pop-up indicates that the device is ready to be used. The SM-USB-DIG Platform uses the human interface
device drivers that are part of the Microsoft
®
Windows
®
operating system.
Figure 6. USB DIG Platform Driver Installation Confirmation
7
SBOU101 – March 2011
AMC80EVM
© 2011, Texas Instruments Incorporated