Microchip Technology TDGL003 - chipKIT Max32 Development Board TDGL003 TDGL003 Guida Informativa
Codici prodotto
TDGL003
c
c
h
h
i
i
p
p
K
K
I
I
T
T
™
™
M
M
a
a
x
x
3
3
2
2
™
™
J
J
u
u
m
m
p
p
e
e
r
r
S
S
e
e
t
t
t
t
i
i
n
n
g
g
s
s
Revision: May 23, 2011
1300 NE Henley Court, Suite 3
Pullman, WA 99163
(509) 334 6306 Voice | (509) 334 6300 Fax
Doc: DSD-0000301
page 1 of 2
Copyright Digilent, Inc. All rights reserved. Other product and company names mentioned may be trademarks of their respective owners.
The chipKIT™ Development Platforms are based off the PIC32 Microcontroller. These are
32-bit products that bring unprecedented features to the Arduino™ community. In order to
maintain compatibility with existing hardware/software while maintaining user accessibility
to these advanced features, additional jumpers and row headers are provided. This
document describes the functionality of the jumpers listed in figure 1.
32-bit products that bring unprecedented features to the Arduino™ community. In order to
maintain compatibility with existing hardware/software while maintaining user accessibility
to these advanced features, additional jumpers and row headers are provided. This
document describes the functionality of the jumpers listed in figure 1.
Figure 1: chipKIT™ Max32 Jumpers
Jumper Function
JP1
POWER SELECT: Used to connect/bypass on-board 5V regulator when
using a power supply connected to J2
using a power supply connected to J2
J4 supply is regulated (i.e. 5V will be
present on 5V pin)
J4 supply bypasses regulator (i.e.
Supply voltage will be present on 5V
pin)
Note: A 3.3V on-board regulator will always be enabled regardless of JP1
settings to protect the PIC32 MCU
settings to protect the PIC32 MCU
Not sure what this does? Play it safe and keep JP1 on the two right-most
pins. (i.e. J2 supply is regulated)
pins. (i.e. J2 supply is regulated)