Freescale Semiconductor Development System TRK-USB-MPC5602P TRK-USB-MPC5602P TRK-USB-MPC5602P Manuale Utente
Codici prodotto
TRK-USB-MPC5602P
6
TRK-USB-MPC5602P EVB User Manual
Qorivva software tools will work with the TRK-USB-MPC5602P. Please refer
to Section 7 - TRK-USB-MPC5602P CODE DEVELOPMENT SOFTWARE
for more information.
to Section 7 - TRK-USB-MPC5602P CODE DEVELOPMENT SOFTWARE
for more information.
5.3
Run Mode
The TRK-USB-MPC5602P’s rich component list empowers it to perform a
variety of tasks. Once an application is developed, debugged, and
programmed properly into the microcontroller’s internal flash memory, it can
run with or without connecting to a host.
variety of tasks. Once an application is developed, debugged, and
programmed properly into the microcontroller’s internal flash memory, it can
run with or without connecting to a host.
5.4
External JTAG/Nexus Mode
The TRK-USB-MPC5602P has an optional JTAG/Nexus header for
debugging and programming the on-board MPC5602P microcontroller using
an external Qorivva hardware tool, such as P&E’s USB Multilink or Cyclone
MAX. Please refer to Section 8 - TRANSITIONING TO YOUR OWN
TARGET for more information. A user can take advantage of this mode to
develop a target-specific MPC5602P system and compare it with the TRK-
USB-MPC5602P when necessary.
debugging and programming the on-board MPC5602P microcontroller using
an external Qorivva hardware tool, such as P&E’s USB Multilink or Cyclone
MAX. Please refer to Section 8 - TRANSITIONING TO YOUR OWN
TARGET for more information. A user can take advantage of this mode to
develop a target-specific MPC5602P system and compare it with the TRK-
USB-MPC5602P when necessary.
6
JUMPER SETTINGS
This section describes the various jumpers settings that are available on the
TRK-USB-MPC5602P. Figures depict the default setting for each jumper.
TRK-USB-MPC5602P. Figures depict the default setting for each jumper.
6.1
OSJTAG Bootloader Enable
6.1.1
J3 - OSJTAG Bootloader Enable
1-2 Forces OSJTAG to start up in bootloader mode for firmware updates
(default: OFF)
(default: OFF)
Figure 6-2: OSJTAG IRQEnable (J3)