Redpitaya RED PITAYA, OPEN SOURCE LAB RED Pitaya V 1.1 Scheda Tecnica
Codici prodotto
RED Pitaya V 1.1
○ 17,600 LUTs
○ 28k Logic Cells
○ 80 DSP slices
○ Dual ARM® Cortex™A9
○ 28k Logic Cells
○ 80 DSP slices
○ Dual ARM® Cortex™A9
● Memory: 4 Gb DDR3 SDRAM (512 MB)
● SD card:
● SD card:
○ Card type: micro SD
○ Supported standard: SD/SDIO 2.0/MMC3.31
○ File System: FAT32 (255 heads, 63 sectors)
○ Maximum card size: 32 GB (tested with: Apacer microSD HC 4GB Class 4 and
○ Supported standard: SD/SDIO 2.0/MMC3.31
○ File System: FAT32 (255 heads, 63 sectors)
○ Maximum card size: 32 GB (tested with: Apacer microSD HC 4GB Class 4 and
others)
● WiFi:
○ WiFi USB dongles: tested with Edimax EW7811Un
● Fan: Optional fan power supply (5V)
● Power supply: (O)
● Power supply: (O)
○ Voltage: 5 V
○ Current: 2 A
○ Connector type: micro USB
○ Compliant with relevant regulation standards
○ Recommended power supply: HNP10ImicroUSB
○ Current: 2 A
○ Connector type: micro USB
○ Compliant with relevant regulation standards
○ Recommended power supply: HNP10ImicroUSB
● Dimensions: 107 mm x 60 mm x 21 mm (W)
● Power consumption: typically < 0.9 A @ 5V (P)
● Environmental conditions:
● Environmental conditions:
○ Temperature:
■ Minimum ambient operating temperature: 5 °C
■ Maximum ambient operating temperature: 30 °C (P)
■ Storage temperature range from 50 °C to 150 °C
■ Laboratory ambient temperature range: 22 °C ± 2 °C (R)
■ Exposed surface temperature: < 70 °C (Q)
■ Maximum ambient operating temperature: 30 °C (P)
■ Storage temperature range from 50 °C to 150 °C
■ Laboratory ambient temperature range: 22 °C ± 2 °C (R)
■ Exposed surface temperature: < 70 °C (Q)
■ Maximum Zynq SoC IC operation temperature: 85 °C
○ Humidity: 15 % 85 % (non condensing)
Notes:
A. Input capacitance depends on jumper settings and may vary.
B. A 50 Ω termination can be connected through an SMA tee in parallel to the input for
B. A 50 Ω termination can be connected through an SMA tee in parallel to the input for
measurements in a 50 Ω system.
C. Crosstalk measured with high gain jumper setting on both channels. The SMA
connectors not involved in the measurement are terminated.