Gw Instek GSP-9300 TGSpectrum analyzer, spectrum analyzerBandwidth (RBW) 1 Hz - 1 MHz (1-3-10) GSP-9300 TG Scheda Tecnica
Codici prodotto
GSP-9300 TG
GSP-9300 Programming Manual
28
Settings
1. Press
System
>More[F7]>RmtInterface[F1]>
LAN[F2]>LAN Config[F1] to set the LAN
settings:
settings:
IP Address[F1]
Sets the IP address.
Subnet Mask[F2]
Sets the subnet mask.
Default
Gateway[F3]
Gateway[F3]
Sets the default gateway.
DNS Server[F4]
Sets the DNS server address
LAN Config[F5]
Toggles the LAN
configuration between DHCP
and manual settings.
configuration between DHCP
and manual settings.
Hint: Use dotted decimal notation when entering
IP addresses, ie., 172.16.20.8
IP addresses, ie., 172.16.20.8
2. Press Apply[F6] to confirm the LAN
configuration settings.
Display Icon
The LXI icon turns green when connected
to a LAN and will flash if the
“Identification” setting is on, see page 37.
to a LAN and will flash if the
“Identification” setting is on, see page 37.
Set Password
The password on the LXI webpage can be set
from the spectrum analyzer. The password is
shown in the system information.
from the spectrum analyzer. The password is
shown in the system information.
By default the password is set to: lxiWNpwd
3. Press
System
>More[F7]>RmtInterface
Config[F1]>LAN[F2]>LXIPassword[F3] to set
the password.
the password.
4. Enter the password using the
F1~F7 keys, as shown below, or
use the numeric keypad to enter
numbers:
use the numeric keypad to enter
numbers:
7
8
9
6
5
4
1
2
3
/
0