Mikroelektronika MikroE Development Kits MIKROE-1470 Scheda Tecnica

1. Introduction

Once you have soldered the headers your 
board is ready to be placed into desired 
mikroBUS

™

 socket. Make sure to align the 

cut in the lower-right part of the board 
with the markings on the silkscreen at 
the mikroBUS

™

 socket. If all of the pins are 

aligned correctly, push the board all 

the way into the socket.

3. Plugging the board in

2

3

2. Soldering the headers

1

4. Essential features

Turn the board upward again. Make sure 
to align the headers so that they are 
perpendicular to the board, then solder the 
pins carefully.

Turn the board upside down so that 
bottom side is facing you upwards. 
Place shorter pins of the header into the 
appropriate soldering pads.

Before using your click

™

 board, make sure 

to solder 1x8 male headers to both left 
and right side of the board. Two 1x8 male 
headers are included with the board in 
the package.

click

BOARD

www.mikroe.com

Fiber Opt Click 5V Manual

0 100000 023945

5V

Fiber Opt click

™

 is an accessory board in 

™

 form factor. It’s a compact 

and  easy  solution  for  adding  fiber-optic 
communication to your design. It features 

 fiber-optic photodiode, 

fiber-

optic LED diode as well as two operational 
amplifiers.  Fiber  Opt  click

™

 communicates 

with the target board microcontroller via 

™ 

UART (TX, RX), INT and PWM 

lines. The board is designed to use 5V power 
supply only. LED diode (GREEN) indicates 
the presence of power supply.

Fiber Opt click™ with it’s 

and 

results  in  support  for  fiber-optic 

communication. Each of the plastic optic 
connector features an internal micro-lens and 
a precision-molded PBT housing to ensure 
efficient  optical  coupling  with  plastic  fiber 
cable. The board can achieve data rates up 
to 512 Kbps. These features make this board 
ideal for data links, local area networks, motor 
controller triggering, medical instruments, 
EMC/EMI signal isolation and many more.

Fiber Opt 

click