Atmel Xplained Pro Evaluation Kit ATSAMD20-XPRO ATSAMD20-XPRO Scheda Tecnica

Codici prodotto
ATSAMD20-XPRO
Pagina di 660
613
Atmel | SMART SAM D20 [DATASHEET]
Atmel-42129K–SAM-D20_datasheet–06/2014
2.
Decoupling capacitor should be placed close to the device for each supply pin pair in the signal group.
34.6.3 External Real Time Oscillator
The low frequency crystal oscillator is optimized for use with a 32.768kHz watch crystal. When selecting crystals, load 
capacitance and crystal’s Equivalent Series Resistance (ESR) must be taken into consideration. Both values are 
specified by the crystal vendor.
SAM D20 oscillator is optimized for very low power consumption, hence close attention should be made when selecting 
crystals, see 
 for maximum ESR recommendations on 9pF and 12.5pF crystals.
The Low-frequency Crystal Oscillator provides an internal load capacitance of typical 3.05pF and 3.29pF. Crystals with 
recommended 12.5pF load capacitance can be without external capacitors as shown in 
Note:
Maximum ESR is typical value based on characterization. These values are not covered by test limits in 
production.
Figure 34-7. External Real Time Oscillator without Load Capacitor
Crystals specifying load capacitance (CL) higher than 12.5pF, require external capacitors applied as described in 
.
To find suitable load capacitance for a 32.768kHz crystal, consult the crystal datasheet.
Figure 34-8. External Real Time Oscillator with Load Capacitor
Notes: 1.
These values are given only as typical examples.
2.
Decoupling capacitor should be placed close to the device for each supply pin pair in the signal group.
Table 34-6. Maximum ESR Recommendation for 32.768kHz Crystal
Crystal C
L
 (pF)
Max ESR [k
Ω]
12.5
313
Table 34-7. External Real Time Oscillator Checklist
Signal Name
Recommended Pin Connection
Description
XIN32
Load capacitor 22pF
Timer oscillator input
XOUT32
Load capacitor 22pF
Timer oscillator output
XOUT32
XIN32
32.768kHz
XOUT32
XIN32
32.768kHz
22pF
22pF