Mikroelektronika MikroE Development Kits MIKROE-1203 Scheda Tecnica

1. Introduction

Once you have soldered the headers your 
board is ready to be placed into desired 
mikroBUS

™

 socket. Make sure to align the 

cut in the lower-right part of the board 
with the markings on the silkscreen at 
the mikroBUS

™

 socket. If all of the pins are 

aligned correctly, push the board all 

the way into the socket.

3. Plugging the board in

2

3

2. Soldering the headers

1

4. Essential features

Turn the board upward again. Make sure 
to align the headers so that they are 
perpendicular to the board, then solder the 
pins carefully.

Turn the board upside down so that 
bottom side is facing you upwards. Place 
shorter parts of the header pins in both 
soldering pad locations.

USB UART 

click

Before using your click board

™

, make sure 

to solder 1x8 male headers to both left 
and right side of the board. Two 1x8 male 
headers are included with the board in 
the package.

click

BOARD

www.mikroe.com

USB UART click Manual

0 100000 021231

USB UART Click

™

 with it’s 

  IC 

gives additional serial UART communication 
via USB cable.

 

The 

contains 

integrated 1024 bit EEPROM, 128 bytes 
long receive buffer, 256 bytes long transmit 
buffer, configurable CBUS I/0 pins and entire 
USB protocol handled on the chip. The board 
contains RX and TX LED diodes that indicate 
the transmit and receive data via USB.

USB UART Click

™

 is an accessory board in 

mikroBUS™

 form factor. It’s a compact 

and easy solution for adding serial UART 
communication via USB cable. It features 

 USB-to-UART interface module 

as well as USB MINI B connector. USB UART 
Click

™

 communicates with target board via 

UART interface. The board is designed to 
use 3.3V or 5V I/O level.

 

It has a LED diode 

(GREEN) that indicates the presence of 
power supply.