Secutech Radio modules ST002005 Scheda Tecnica
Codici prodotto
ST002005
Security & Electronic Technologies GmbH
Page 23
Remarks for mounting the SECU-BAR 125
SECU-BAR 125 uses an insulated housing for DIN-rail mounting. The insu-
lation provides utmost safety during the installation
SECU-BAR 125 uses an insulated housing for DIN-rail mounting. The insu-
lation provides utmost safety during the installation
– short circuits via the
housing, indirect touching of live conductors is impossible.
Please, adhere to all local safety regulations and standards (like DIN VDE
0100, VBG4, etc.) and follow the instructions of the manufacturer and of the
plant manager.
The wiring of the connection terminals is done with the provided self-
clearing spring-clips and plus-minus screws.
Please, adhere to all local safety regulations and standards (like DIN VDE
0100, VBG4, etc.) and follow the instructions of the manufacturer and of the
plant manager.
The wiring of the connection terminals is done with the provided self-
clearing spring-clips and plus-minus screws.
First of all install the wiring to the SECU-DATA xxxx, and afterwards the
connections to the not intrinsically safe power supply. Snap the SECU-
DATA 125 simply on to the DIN-rail.
Wiring of the SECU-DATA xxxx:
connections to the not intrinsically safe power supply. Snap the SECU-
DATA 125 simply on to the DIN-rail.
Wiring of the SECU-DATA xxxx:
1. For the wiring use round wires of type: 0,08
– 2.5 mm
2
cross sec-
tion, AWG 28
– 12, flame propagation characteristics as per IEC
60332-1-2, within a round cable to ensure the water protection
2. Strip the wires off app. 5-6 mm
3. Depress each of the levers of the terminal block (Type WAGO se-
ries 256, ATEX certified for EEx-i applications) with a small screw
driver
driver
4. Put the stripped wire end into the terminal and release the lever
again
5. Close the SECU-DATA xxxx housing again and mount it to the final
location with the supplied screws in the provided holes of the hous-
ing. Take care for correct positioning of the sealing elements. For
metal base planes ensure that there is some space between the
RF-antenna and the metal material to maintain the best effective
range of the RF connection.
ing. Take care for correct positioning of the sealing elements. For
metal base planes ensure that there is some space between the
RF-antenna and the metal material to maintain the best effective
range of the RF connection.
Remark: After delivery one cable gland is sealed waterproof with a cap.
This is useful if only one cable gland shall be used.