STMicroelectronics Nucleo Development Board for STM32 Microcontrollers NUCLEO-F103RB NUCLEO-F103RB Scheda Tecnica
Codici prodotto
NUCLEO-F103RB
DocID025833 Rev 3
UM1724
Hardware layout and configuration
48
5.2 Embedded
ST-LINK/V2-1
The ST-LINK/V2-1 programming and debugging tool is integrated in the STM32 Nucleo
boards.
boards.
The ST-LINK/V2-1 makes the STM32 Nucleo boards mbed enabled.
The embedded ST-LINK/V2-1 supports only SWD for STM32 devices. For information about
debugging and programming features refer to
debugging and programming features refer to
ST-LINK/V2 features.
The changes versus ST-LINK/V2 version are listed below.
New features supported on ST-LINK/V2-1:
–
–
USB software re-enumeration
–
Virtual com port interface on USB
–
Mass storage interface on USB
–
USB power management request for more than 100
mA power on USB
Features not supported on ST-LINK/V2-1:
–
–
SWIM interface
–
Minimum supported application voltage limited to 3
V
There are two different ways to use the embedded ST-LINK/V2-1 depending on the jumper
states (see
states (see
Program/debug the MCU on board (
Program/debug an MCU in an external application board using a cable connected to
SWD connector CN4 (
SWD connector CN4 (
Figure 5. Typical configuration
Table 3. Jumper states
Jumper state
Description
Both CN2 jumpers ON
ST-LINK/V2-1 functions enabled for on board programming
(default)
(default)
Both CN2 jumpers OFF
ST-LINK/V2-1 functions enabled for external CN4 connector
(SWD supported)
(SWD supported)
069
+DUGZDUHUHTXLUHPHQWV
86%FDEOHW\SH$WRPLQL%
FRPSXWHUZLWK:LQGRZV;39LVWDRU
86%FDEOHW\SH$WRPLQL%
FRPSXWHUZLWK:LQGRZV;39LVWDRU
'HYHORSPHQWWRROFKDLQ
,$5(:$50
.HLO0'.$50
.HLO0'.$50
*&&EDVHG,'(