Reely 4WD RtR 2.4 GHz GSC4283BBDGOG. Scheda Tecnica

Even though the model and the remote control system were built with the latest available technology, there can still 

be malfunctions or errors. For this reason, we would like to give you some information on how to deal with possible 

problems. Also observe the enclosed operating instructions for the remote control system.
The model doesn’t respond or does not respond properly
•  The speed controller recognises the transmitter‘s neutral position only within a specific range. If the trim at the

transmitter is misadjusted too far, the speed controller will not react for safety reasons. In this case, switch off the 

speed controller and correct the trim at the transmitter (put the trim for the driving function to the centre position). 

Then switch on the speed controller again.

•  For 2.4 GHz remote control systems, the receiver must be taught to the transmitter. This process may be referred

to by the terms of „Binding“ or „Pairing“. The teaching process usually was performed by the manufacturer already;

however, it can, of course, also be done by you. Also observe the separately enclosed operating instructions for the 

remote control system. 

•  Are the vehicle drive battery or the batteries/rechargeable batteries in the transmitter discharged? Exchange the

drive battery or batteries/rechargeable batteries in the transmitter for new ones.

•  Depending on the drive battery used, the corresponding battery type (e.g. LiPo) must be programmed. Depending

on battery type, the speed controller uses the required undervoltage recognition (e.g. at one LiPo battery, the speed 

controller switches off the motor at a battery voltage of 6.0 V (this means a voltage of 3.0 V per LiPo cell). The LED 

on the speed controller flashes green in this case.

  At incorrect programming of the battery type, the speed controller may switch off too late, which will lead to deep 

discharge of the connected rechargeable battery. 

•  Did you switch on the transmitter first and then the speed controller? The speed controller will not work for reasons

of safety in case of reverse order.

•  Is the drive battery connected to the speed controller correctly? Check the plug connection for whether it is conta-

minated or oxidised.

•  Is the vehicle too far away? With a fully charged drive battery and fully charged batteries/rechargeable batteries

in the transmitter, the range should be at least 50 m. The range can be decreased by outside influences, such as

interference on the transmitter frequency, or proximity to other transmitters (not only remote controller transmitters 

but also WLAN/Bluetooth devices that also use a transmission frequency of 2.4 GHz), metal parts, buildings, etc.

 The position of transmitter and receiver aerial to each other very strongly influences range. It is best when both the

transmitter and receiver aerial are vertical. If you point the transmitter aerial at the vehicle, the range will be very 

short!

•  Check the correct position of the speed controller and steering servo plugs in the receiver. If the plugs are inserted

rotated by 180°, the speed controller and steering servo will not work.

  If, however, the speed controller and steering servo plugs are swapped, the throttle/brake lever controls the steering 

servo, and the wheel controls driving!

•  The speed controller has an overtemperature protection (at approx. +95 °C). If it has been active, wait until the

speed controller has cooled off sufficiently again.

•  If the speed controller does not receive any valid signal from the receiver, it will switch off the motor for reasons of

safety. In this case, the LED on the speed controller remains lit green.