Carson BRUSHLESS-SET DRAGSTER PRIME 10T 500906162 Manuale Utente
Codici prodotto
500906162
41
CARSON DRAGSTER Brushless-Regler
GB
Flashing
frequency
frequency
1
2
3
4
5
6
7
8
9
10
Drag brake (%)
OFF
5
10
15
20
25
30
35
40
45
11. Setting the Drag Brake (Engine Brake)
The drag brake simulates the friction of the brushes of brush motors.
•
Press the SET button down until the blue LED light up 4 times. Release the SET
button again.
button again.
•
The red LED start flashing. This shows that you are in the mode for setting the
parking brake.
parking brake.
•
Press the SET button repeatedly until you reach the required setting.
The red LED flash at the next highest speed.
The red LED flash at the next highest speed.
•
By repeatedly pressing briefly on the SET button you can scroll through the
settings.
settings.
•
When you reach the required setting, hold down the SET button for approx. 2
seconds; the setting is stored.
seconds; the setting is stored.
•
Once you have stored the setting, the red and blue LEDs flashes alternate 3
times to show that you are leaving the programming mode. Switch controller
off and on again to activate the selected settings.
times to show that you are leaving the programming mode. Switch controller
off and on again to activate the selected settings.
•
If you do not press the SET button for more than 10 seconds the
controller reverts to the last setting and is ready for use again.
controller reverts to the last setting and is ready for use again.
Blue LED
Red LED