Carson RC model speedboat ARR 600 mm 500106003 Scheda Tecnica

G

Switch(es) on transmitter or/and model is/

are “off”

Switch on

Weak or no battery in the model

Insert fully charged battery

The overheat cut-out has stopped the model 

due to overheating

Switch off the receiver. Allow the RC model to 

cool down for approximately 30 minutes

Weak rechargeable battery/battery in trans-

mitter or model

Insert fully charged battery or new battery

1.   Turn off the model. Disconnect the power pack.
2.  Turn off the transmitter.

•  Never touch or hinder rotating parts and propeller. 
•  The motor and battery may become hot during operation. Take 

care when you handle them.

•  Remove the batteries from the model and the transmitter when 

they are not in use.

•  Always dry off and clean immediately after use.
•  Never store the components in a damp or wet state.
•  To avoid corrosion, the product should not come into  

contact with salt-water.

•  The housing of the speed controller and servo are waterproof.  

The connections to the power pack, the motor and the receiver  

are not watertight!

•  Take care of the exposed connections and keep them away from 

liquids and damp.

•  Make sure that electronic components such as the receiver, power 

pack, servo and motor are protected from water and damp.

Your model must be regularly checked for proper control functions. The drive and all electronic components must be checked before each use. 

Ensure that allows all rotating and moving parts move smoothly cultivation. Please clean the model only with a soft moistened cloth.