Sygonix 43192V Manuale Utente

31

<Auto scan> controls the automatic scanning of the high-speed dome camera from left to right 
boundary after starting. 

<Limit Scan> controls the limit scanning of the high-speed dome after starting. 

<Patrol> runs the patrol scanning of the high speed-dome after starting. 

<Pattern> runs the pattern scanning of the high-speed dome after starting. 

<Menu CTRL> after pressing this, the high-speed dome menu will appear after starting. After 
entering the high-speed dome menu, use “IRIS+” to confirm and use “IRIS-” to cancel. 
Left-click to move the cursor up or down. 

Operating functions need to be supported by head-end equipment and matched with the 

relevant protocols. 
“PRESET” Adjust the direction and angle of the camera, input the corresponding preset point 

numbers, and then click “

” to preset the point numbers of the menu. 

Input the preset point number, and click “

”, to automatically switch the camera to the 

corresponding location of the preset point.   

The functions of these menu options may vary depending on the make and model of the PTZ 
camera being used. For a detailed explanation of the available options, refer to the user manual 
included with the PTZ camera. 

The following status icons will appear in the upper right corner of each channel frame. 

  This indicates that the channel has detected motion while in motion-detection mode.   

  This indicates that the channel has detected that something has set off the sensor alarm 

while in alarm mode. 

This indicates that the channel is running in normal recording mode.