Siemens SPS starter kit 6ED1057-3BA10-0AA8 6ED1057-3BA10-0AA8 Scheda Tecnica
Codici prodotto
6ED1057-3BA10-0AA8
LOGO! functions
4.4 Special functions list - SF
LOGO!
210
Manual, 06/2014, A5E33039675
If retentivity is not set, output Q is initialized after a power failure according to your
configuration at the "Start" parameter.
Setting the Par parameter
View in programming mode (example):
1. Position the cursor on "Par". Press OK.
2. Press to position the cursor on the "On" line.
1. Position the cursor on "Par". Press OK.
2. Press to position the cursor on the "On" line.
3. Press OK. Select "Momentary pushbutton" or "Switch": Press or .
4. Press to move the cursor to "Start" line.
5. To change the "Start" state: Press or .
5. To change the "Start" state: Press or .
6. Confirm your entries with OK.
View in parameter assignment mode (example):
Here, you can set or reset the "Switch" parameter (On/Off). When in RUN, LOGO! shows the
View in parameter assignment mode (example):
Here, you can set or reset the "Switch" parameter (On/Off). When in RUN, LOGO! shows the
following display:
Let us assume you want to set "Switch" (On).
1. Press OK (the cursor is now positioned on "Off").
2. To change from "Off" to "On": Press or .
3. Confirm your entries with OK.
1. Press OK (the cursor is now positioned on "Off").
2. To change from "Off" to "On": Press or .
3. Confirm your entries with OK.