Advantech ADAM-6050 18-Channel Isolated Digital I/O Modbus TCP Module ADAM-6050-BE Scheda Tecnica

Below are the steps to define the mapping relationship:
1.

Select the input channel by the Channel combo box in Source.

2.

Use Period time numeric control, Deviation enable (C.O.S) check 
box (for analog modules) or Change of state (C.O.S) check box 
(for digital modules), and Deviation Rate numeric control in the 
Source area to define when to transfer the data for that channel. 
The configuration operation is similar to Basic mode.                           

3.

Define the target device for that channel by entering its IP address 
into the IP text box in the Destination area. Choose the correct 
module name from the Name combo box, and choose the output 
channel to receive the data by the Channel combo box. 

4.

After you have completed all these configurations for this channel, 
click the Config to list button. You can see your configuration for 
that channel is displayed by the mapping table below the Source 
and Destination area.