ConiuGo 700100140 Scheda Tecnica
33
Point 3.).
5.
Set the baud rate to 57600 and press „OK“.
6. Now you are in the main terminal window. To check the work of the modem
you hav to enter following keys:
ATE1 und Return.
7. Now you transfer hand over the PIN Nummer (e.g. 1234, example) with the
command AT+CPIN=“1234“ and Enter.Wait on the answer „OK“.
The “ before and after the PIN no. is very important! Check the enter of the
PIN with the command AT+CPIN? and Enter
The “ before and after the PIN no. is very important! Check the enter of the
PIN with the command AT+CPIN? and Enter
– it has to answer „...READY“.
8. Now check the signal quality of the GSM signal strenght with the command
AT+CSQ Enter. The value after „CSQ: “ must be greater then 000 sein, e.g.
...014,...“. With the command AT+COPS? and Enter appears the name of
the choosen GSM provider.
...014,...“. With the command AT+COPS? and Enter appears the name of
the choosen GSM provider.
9.
Now you can exit the „HyperTerminal“ software and save the „HyperTermi-
nal“ settings – next time you only have to hand over the PIN no. with the
Hyper Terminal sofware settings.
nal“ settings – next time you only have to hand over the PIN no. with the
Hyper Terminal sofware settings.
9.3 Reboot the system
Now reboot the computer so that the setting of the GPRS manager could be
saved and fixed into the computer system settings. (Hint: The PIN number
you have given to the modem is further existent/known if the power connec-
tion of the modem was not cut. The modem is furthermore booked into the
GSM network after the system reboot!)
9.4 Basic settings for a GPRS connection
5. After reboot the system the GPRS manager poped up automatically for in-
stallation of a GPRS connection. (Be sure that the GPRS modem is fur-
thermore at work and the PIN no. is transmitted to the modem or deactivat-