Buffalo NAS server 6 TB LS421-6TBR LS421-6TBR LS421-6TBR Scheda Tecnica
Codici prodotto
LS421-6TBR
53
4
Check the IP address of the LinkStation or TeraStation that you want to set as the backup target. Click Add, enter
the IP address of the target LinkStation or TeraStation, and click Close.
the IP address of the target LinkStation or TeraStation, and click Close.
If your setup meets these requirements, you don’t have to configure these settings.
• The source and target LinkStations are on the same network.
• No backup password is set for the target LinkStation.
• No LinkStation from outside the subnet, connected by a VPN, is used.
• The source and target LinkStations are on the same network.
• No backup password is set for the target LinkStation.
• No LinkStation from outside the subnet, connected by a VPN, is used.
Notes:
• To back up data between LinkStations or TeraStations on a network using jumbo frames, make sure that both de-
• To back up data between LinkStations or TeraStations on a network using jumbo frames, make sure that both de-
vices are configured to use identical (or similar) Ethernet frame sizes. If Ethernet frame sizes are significantly dif-
ferent, the backup job may not be properly performed. In such a case, select the default frame size (1518 bytes).
ferent, the backup job may not be properly performed. In such a case, select the default frame size (1518 bytes).
• You can also specify hostname by a fully qualified domain name (FQDN).
Configuring a Backup Job
1
1
In Advanced Settings, Click Backup.