Buffalo NAS server 8 TB TeraStation 1400 TS1400D0804-EU TS1400D0804-EU Scheda Tecnica

91

The power LED will blink during bootup or shutdown.

If there is an error, the power LED will blink red. For TS1200D models, the following blink patterns will give the error 
code. You can also see any errors in NAS Navigator2.

Place of Error Code

Status

10s Place of Error Code

The LED flashes for 1.0 second every 0.3 seconds. This gives the tens place 
of the error code.

1s Place of Error Code

The LED flashes for 0.5 seconds every 0.3 seconds. This gives the ones 
place of the error code.

Error Code

Description

Corrective Action

E10

The TeraStation is running on the UPS 
battery due to a power outage. The 
system will now be shut down safely.

Check that power is being supplied to 
the UPS, and if there are no problems, 
turn on the TeraStation.

E11

An error occurred in the fan speed.

Check the fan. Use compressed air or 
tweezers to remove any dust or foreign 
objects. Confirm that the fan is spinning 
normally. If it is not, contact Buffalo 
technical support for assistance.

E12

The system is overheating.

Do not place objects in the area 
around the TeraStation. Also, move the 
TeraStation to a cool location.

E13

An error occurred in the RAID array. The 
TeraStation is in degraded mode.

Replace the defective drive. Reboot the 
TeraStation and rebuild the RAID array.

E14

RAID array x cannot be mounted.

Run the RAID array disk check in 
Settings.

E15

The bad sectors have reached a 
dangerous level.

Replace the defective drive.

E16

Unable to find hard drive x.

Hard drive x may be disconnected 
or may have failed. Shut down the 
TeraStation and reinstall the hard drive.

E22

Mounting of hard drive x failed.

Format the hard drive. After formatting, 
if the error still appears after rebooting, 
replace the hard drive. If the error 
is displayed again, contact Buffalo 
technical support for assistance.