Buffalo LinkStation 420 2TB P-LS420D0202-EU-3 Scheda Tecnica
Codici prodotto
P-LS420D0202-EU-3
Using your LinkStation
LinkStation User Manual
87
UPS Settings
A UPS (uninterruptable power supply) can automatically shut down your LinkStation in case of a
power outage. To use the LinkStation with a UPS, configure the following settings:
power outage. To use the LinkStation with a UPS, configure the following settings:
1
2
3
2
3
Plug the Power cable of UPS to a wall socket.
Connect the AC adapter of the LinkStation to the UPS.
Connect the UPS and the LinkStation with a USB cable.
4
Turn on the UPS, then the LinkStation.
5
In the Web Admin interface, navigate to [System] -
[Power Management] - [UPS Settings] and click [Modify
Settings].
[Power Management] - [UPS Settings] and click [Modify
Settings].
6
The LinkStation is now configured to work with the UPS.
Note: If the LinkStation shuts down automatically due to a power outage, make sure that the power
issue is resolved before turning it back on. If the LinkStation is turned back on while it’s still
running on the UPS battery, the UPS will not shut it down again, even if the battery runs low.
running on the UPS battery, the UPS will not shut it down again, even if the battery runs low.
System Power Management
1 If your LinkStation is connected directly to the
UPS, select [synchronize with UPS connected
to this LinkStation]. To have the UPS shut down
multiple LinkStations on the same network, select
[synchronize with UPS connected to other LinkStation
on the network] and enter the IP address of the
LinkStation that is connected directly to the UPS in
the field below.
to this LinkStation]. To have the UPS shut down
multiple LinkStations on the same network, select
[synchronize with UPS connected to other LinkStation
on the network] and enter the IP address of the
LinkStation that is connected directly to the UPS in
the field below.
2 Click [Save].