Buffalo NAS server 8 TB TeraStation 5400 WD Red TS5400DWR0804-EU built-in Western Digital RED TS5400DWR0804-EU Scheda Tecnica

154

Click 

 to the right of “SNMP”.

Click Edit.

Configure the desired settings, then click OK.

The TeraStation’s settings can be saved to a USB memory device and restored to another TeraStation. Use this function to 
back up and copy settings to a new TeraStation.

Make a note of the hard drive configuration (number of hard drives, RAID, LVM, etc.) of the TeraStation where the 
settings were saved. Make sure that any TeraStation that you apply these settings to has exactly the same hard drive 
configuration before you apply the settings. If the drive configuration is different, you may get unexpected results.
The following settings are not saved or restored:

Category

Settings

File Sharing

Shared folder information of USB drive and media cartridge

Drives

All settings in “Drives”
All settings in “RAID” - “Options” - “RAID Array Settings”
All settings in “LVM”
All settings in “iSCSI”
USB drive and media cartridge information

Network

All settings in “IP Address”
All settings in “Port Trunking”

Backup

All settings in “Failover”

Management

All settings in “Name”
All settings in “UPS Sync”
All settings in “SSL”
Display language in Settings

Insert a USB memory device into a USB port on the TeraStation.

Notes: 
•  Use a USB 2.0 port. If your TeraStation has both USB 3.0 and USB 2.0 ports, make sure that you use one of the USB 

2.0 ports.

•  The USB memory device should have a capacity of at least 1 GB.
•  Any data stored on the USB memory device will be deleted.

In Settings, click Management.