Buffalo NAS server 8 TB TeraStation 5400 Rack WD Red TS5400RWR0804-EU TS5400RWR0804-EU Scheda Tecnica

157

In Settings, navigate to Management-Restore/Erase-USB Options.

Select Create a USB drive for initializing settings.

Note: All data on the USB flash drive will be erased!

Select the USB memory device from “Target USB drive”, then click Execute.

Enter the 4 digit confirmation number and click OK. The TeraStation will create the initialization drive. This will take 
about a minute.

When the “finished” dialog opens, the USB initialization drive is ready to use. Dismount the USB drive before 
unplugging it. See “Dismounting Drives” in chapter 4 for the instructions on dismounting drives.

To initialize the settings on your TeraStation with the USB drive as created in above, follow the procedure below.

Create a USB “initialization drive” as described above.

Insert the USB drive into a USB 2.0 port (not a USB 3.0 port) on the TeraStation.

Set the boot mode switch to “USB”.

Press the power button to turn on the TeraStation.

When the message “Recovery I41 PushFuncToStart” appears on the LCD panel, press the function button.

It will take several minutes for initializing the settings. The TeraStation will shut down when it’s finished.

After shutdown, “Recovery I39 Change Boot” is displayed.

Set the boot mode switch to “HDD” position.

Press the power button to start the TeraStation.

A password initialization drive can reset the administrator password to its default value (“password”). This could be very 
useful if you forget your admin password.

Connect a 1 GB or larger USB memory device (not included) to a USB 2.0 port on the TeraStation.

In Settings, navigate to Management - Restore/Erase - USB Options.

Select Create a USB drive for resetting the admin password.