Buffalo LinkStation 420 4TB + BX650CI-GR LS420D0402-EU + BX650CI-GR Scheda Tecnica

LinkStation User Manual

170

Appendix

The following section lists typical occurrences and causes  when you cannot setup the LinkStation 
by using LinkNavigator or cannot use LinkStation even after finishing setup, 

Occurrence: The message "Cannot find LinkStation", "No available LinkStation was found", or 
"Setup cannot be completed" is displayed. 

Cause 1. An Ethernet cable is not connected. 

Reconnect the AC Adapter and the Ethernet cable, and turn on the LinkStation again.

Cause 2. The firewall is enabled, or software running in the background is installed.

Disable the firewall or uninstall software which enables the firewall, and try to search for the 
LinkStation again.

Cause 3. Both wireless and Ethernet Adapter are enabled.

Disable any adapters other than the Ethernet Adapter to connect to the LinkStation.

Cause 4. The defective Ethernet cable or the connection is not stable.

Change a port on the hub to connect or replace the Ethernet cable.

Cause 5. Your Ethernet Board, card, or adapter is malfunctioning.

Replace a Ethernet Board, card, or adapter.

Cause 6. The Ethernet Board you are using or the transfer mode of the hub is not set.

Change the Ethernet Board, or change the transfer mode to [10M half-duplex] or [100M 
half-duplex].

Some Ethernet Boards and hubs may not be connected to the network properly if the trans-
fer mode is set to [Auto Negotiation].

Cause 7. There is a network bridge.

If any network bridge which is not used, delete them.

Cause 8. You are searching from a different network.

You cannot search for the LinkStation over network segments. Connect the LinkStation to 
the same segment as the computer you use for search.