Brother HL-5350DN2LT HL-5350DNLTG2BOM Scheda Tecnica

Control Panel

If there is an error that cannot be cleared by the user, the printer will show that a service call is needed by 
lighting up all the LEDs as shown below.

If you see the service call indication shown above, turn off the power switch, and then turn it back on and try 
to print again.
If the error is not cleared after turning the power switch off and then back on, press Go and Job Cancel 
together, the LEDs will light up as shown in the table below to identify the error.
LED error indication

1

If this error occurs, turn off the printer power switch, wait a few seconds, and then turn it on again. Leave the printer for 15 minutes with the power 
on. If the error occurs again, call your dealer or Brother Customer Service.