Renkforce SAP-702 Hi-Fi Amplifier 29266c Scheda Tecnica
Codici prodotto
29266c
22
b) Connecting the Loudspeaker Outputs
The line towards the loudspeakers must be a bifilar cable. Insulate all connecting terminals.
Ensure there are no sharp edges which could damage the cables.
Only use loudspeakers with a sufficiently high load capacity (see “Technical Data”).
Connect the loudspeakers directly to the miniature amplifier.
Do not use headphone adapters or distribution boxes. If you are unsure about anything, please
contact a specialist.
contact a specialist.
Make sure that all loudspeakers have the correct polarity, i.e. the plus and minus signs must
match.
match.
This amplifier has been designed for a loudspeaker impedance of 8-16 Ohm on each channel.
Only connect one loudspeaker to each output.
Only connect one loudspeaker to each output.
• To open the loudspeaker clamps, press the red/black plastic surface. Slide the stripped end of the loudspeaker cable
into the aperture and release the plastic surface. The loudspeaker cable is clamped and good contact is guaran-
teed.
Connect the right loudspeaker pair to the speaker output R (9):
• Connect the (+) pole of the right loudspeaker to the red speaker clamp.
• Connect the (-) pole of the right loudspeaker to the black speaker clamp.
• Connect the (+) pole of the right loudspeaker to the red speaker clamp.
• Connect the (-) pole of the right loudspeaker to the black speaker clamp.
Connect the left loudspeaker pair to the speaker output L (10):
• Connect the (+) pole of the left loudspeaker to the red speaker clamp.
• Connect the (-) pole of the left loudspeaker to the black speaker clamp.
• Connect the (+) pole of the left loudspeaker to the red speaker clamp.
• Connect the (-) pole of the left loudspeaker to the black speaker clamp.