Nkk Switches Pushbutton 24 Vdc 0.05 A 1 x Off/(On) momentary 1 pc(s) JF15CP2C Scheda Tecnica

Codici prodotto
JF15CP2C
Pagina di 6
J
Series JF
Ultra-Thin Process Sealed Tactiles
www.nkk.com
J34
Indicators
Accessories
Supplement
Tactiles
Keylocks
Rotaries
Pushbuttons
Illuminated PB
Slides
Programmable
Rockers
Touch
Tilt
 
Toggles
Electrical Capacity (Resistive Load)
 
Low/Logic Level: 
  50mA @ 24V DC  
Other Ratings 
   
 
Contact Resistance:   50 milliohms maximum 
 
 
 
Insulation Resistance: 
500 megohms minimum @ 250V DC 
 
Dielectric Strength: 
250V AC minimum for 1 minute minimum 
 
Mechanical Life: 
500,000 operations minimum 
 
 
Electrical Life: 
500,000 operations minimum 
 
 
Nominal Operating Force: 
1.96N for sculptured actuator 
 
 
2.0N for piano actuator 
 
 
3.0N for square & round flush actuators 
 
 
Total Travel:    Flush Actuators .016” (0.4mm)  
 
 
Sculptured & Piano Actuators .031” (0.8mm)    
 
 
Materials & Finishes
 
Actuator: 
Polyamide 
 
Case: 
Glass fiber reinforced polyamide   
 
Seal: 
Nitrile butadiene rubber 
 
Base: 
Glass fiber reinforced polyester 
 
Movable Contact: 
Phosphor bronze with silver plating
 
Stationary Contacts: 
Brass with silver plating
 
Terminals: 
Brass with silver plating
Environmental Data
  Operating Temperature Range: 
–25°C through +85°C (–13°F through +185°F)
 
Humidity: 
90 ~ 95% humidity for 96 hours @ 40°C (104°F)
 
Vibration: 
10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning 
 
 
in 1 minute; 3 right angled directions for 2 hours
 
Shock: 
50G (490m/s
2
) acceleration (tested in 6 right angled directions, with 5 shocks in each direction)
PCB Processing
 
Soldering:   Wave Soldering Recommended.  See Profile A in Supplement section.
 
 
Manual Soldering:  See Profile A in Supplement section.
 
Cleaning: 
Automated cleaning.  See Cleaning specifications in Supplement section.  
 
Standards & Certifications
 
   The JF Series tactiles have not been tested for UL recognition or CSA certification.  
 
   These switches are designed for use in a low-voltage, low-current, logic-level circuit.  
 
 
When used as intended in a logic-level circuit, the results do not produce hazardous energy.
General 
Specifications