Graupner Pistol grip RC 2.4 GHz No. of channels: 3 94004 Manuale Utente

94004 GM-Racing XG-6i 2.0 FHSS Race Spec                                           28

English

This function is used to change the sensitivity of the steering servo around the neutral position. 
It has no effect on the maximum servo travel. Note: When the setting is not determined, or 
the characteristics of the model are unknown, start with 0% ( when EXP is set to 0%, servo 
movement is linear).
1.  Press “ENTER” to see FUNCTION MENU.
2.  Use the +/- Keys to select the ST CURV function and press ENTER.
3.  Use the +/- Key to change the value.
4.  Press EXIT to save and return to FUNCTION MENU, press EXIT again to return to the
 Main 

Screen.

 

STEERING CURVER adjusting value range: -100%~+100%  Default is 0% (Linear)

STEERING EXP ADJUSTMENT
1.  When  you  want  to  quicken  steering  operation,  use  the  (+)  button  to  adjust  the +
 

side. When you want to make steering operation milder, use the (-) button to adjust the

 -side.
2 .  When ending setting, return to the function menu by pressing the (EXIT) button .
 

TERMS: M-MODE, R--RATE

This  function  makes  the  throttle  high  side  and  brake  side  direction  servo  operation 
quicker or milder. It has no effect on the servo maximum operation amount. For the high side, 
selection from among three kinds of curves (EXP/VTR/CUR) is also possible. 
Note: When the course conditions are good and there is no sense of torque at the power  unit,  
set  each  curve  to  the  +  side  (quick  side).  When  the  road  surface is slippery and the 
drive wheels do not grip it, set each curve to the - minus (mild) side. Note: Brake side only has 
EXP curves.
1.  Press “ENTER” to see FUNCTION MENU
2.  Use the +/- Keys to select the TH CURV function and press ENTER.
3.  Press ENTER to select a setting.
4.  Use the +/- Key to change the value.
5.  Press EXIT to save and return to FUNCTION MENU, press EXIT again to return to the 
 Main 

Screen.

ADJUSTMENT METHOD FOR EXP CURVE
Select EXP at setup item “M”, select setup item “R” and make the following adjustments:
1. 

Forward side adjustment:

 

Use the (+) button to adjust the + side when you want to quicken the rise and use the (-) 

 

button to adjust the - side when you want to make the rise milder.

2. 

Brake side adjustment:

 

Select  the  setting  item  „BR“  by  ENTER  button  and  use  the  (+)  button  to adjust the

 

+ side when you want to quicker the rise and use the (-) button to adjust the - side when  

 

you want to make the rise milder.

3.  When ending setting, return to the initial screen by pressing the EXIT.